Intake Design Question

144-250 cid Inline Six Performance
Post Reply
lavron
Site Admin
Posts: 4710
Joined: Sat Nov 01, 2003 9:17 am
Location: Missouri, Ozarks
Contact:

Intake Design Question

Post by lavron »

So, this might sound like a totally hypothetical question, or maybe not :roll: If one was putting 2 progressive 2 barrels on a Ford six, would you want to separate the front and rear parts of the intake with a dividing plate or just leave it open? Or even just have the dividing plate with a hole in it (or some particular size) or not fully seal it around the edges? Or even a butterfly valve between that one could adjust?

Thoughts and opinions?

See Ya,
Mike
Mike's build thread
viewtopic.php?f=9&t=13058
Image

popscomet
Posts: 9687
Joined: Sat Jan 01, 2011 11:19 pm
Location: Jacksonville, Arkansas

Re: Intake Design Question

Post by popscomet »

leave it open !! pop
Image
pop/glenda

lavron
Site Admin
Posts: 4710
Joined: Sat Nov 01, 2003 9:17 am
Location: Missouri, Ozarks
Contact:

Re: Intake Design Question

Post by lavron »

I knew a multi-carb man could answer that :D

See Ya,
Mike
Mike's build thread
viewtopic.php?f=9&t=13058
Image

Post Reply