COMET CENTRAL

My D660YS for a manual transmission fit perfectly. All I had to do was r/r the zbar.

Thank you for the help. Truly appreciated.

I recently installed 2.5" dual exhaust and it comes dangerously close to the rear brake hose. Can anyone offer a solution to reroute or lengthen the hose to avoid contacting the tail pipe? I know the 65 Mustang dual exhaust had a different set of brake lines and brake hose that moved the junction bl...

Do you have any housings to start with or just looking for better ones? I may have a set but the wire leads were cut and the housings have dings. Better than nothing. I think you can use Ford Bronco sockets, but I haven’t tried myself. I don’t need a dash panel, but if I find them we can work someth...

I was under the impression the only modifications were to trim the sides that allows the console to sit lower

I think this is new to the market.

https://www.parts123.com/parts123/dynde ... 1018aAAAMA

When I removed my tank I noticed what appeared to be some type of bedding compound. Almost like plumbers putty between the tank flange and the trunk floor. Does anyone know what this might be? I assume it needs something in between these two surfaces. The "bedding compound" was not adhered and was r...

Lou,

My apologies. I went back and found your original post detailing the gauge work. Really impressive.

Randy

Lou your dash looks great. Where did you source the bezel? Does that mount in the original location without modification?

Technically that vent hole should have a fitting installed with a hose routed up high.

Not sure if you are looking for original, but if you don't care if they are original or not these would work. You can trim the wire to fit or even take the wire off if need be. I use these universal fasteners a lot . They come in many sizes, are cheap and are easy to modify, ( grind to fit etc.) I ...

If you're talking about the trim pieces across the back of a Cali or Cyclone, this is it. https://cometcentral.com/photos/images/2022/02/27/d1b284645dc3fe294a8bc6af735c7293.jpg Jim Thanks Jim. I saw that in the manual but couldn’t find a part number or description. I think I found one actually stuc...

Here’s my work in progress. I just ripped the rear out and I’m waiting on my new 3rd member from
Quick Performance. Went with 3.55 gears and a True Trac. Also replaced the springs and picked up new QA1 shocks.

Does anyone have a picture or a source for the fasteners that secure the 3 aluminum trim pieces between the tail lights? I assume it is some type of T-head bolt?

Can the lower trim be installed after the windshield is in place?