I'm running this r&p set-up but with power assist. https://www.jegs.com/i/Unisteer/668/800 ... JoQAvD_BwE
The front engine cross-member adds a lot of rigidity to the front suspension. Tight and responsive.
Joe
I'm running this r&p set-up but with power assist. https://www.jegs.com/i/Unisteer/668/800 ... JoQAvD_BwE
certainly $1700 would be too pricyfor me but if it bolts in I would assume it is removabe as well, I like my Welders series weld in cross member I would guess well under $500 for my completeM2 install and the little I have drove it around the yard and a short drive up the highway, as soon as it gets aligned it will be the best front suspension the car has ever had (that is not hard from the worn out front supension the car has had since I bought iit in 1979) with R&P and the big stock steering wheel I dont need PS. having a 6cyl and big msnly arm doesn't hurt .of course IMO a 6 cyl in a big bonus I cant wait to get the alignment done and inspected so I can get the liscense on it and start road testing working the bugs out my plans are some trips to town ( 10 miles, then when those are reliable start making my 30 mile trip t get groceries one or two times a month. when those are without inciedence , drive down to my aunt and uncles near Branson,( approx 100 miles) lots of hills and curves, if that is successful then it will be pretty much fully tested and ready for some cruisingJoe Travers wrote: ↑Tue May 18, 2021 12:36 pmI'm running this r&p set-up but with power assist. https://www.jegs.com/i/Unisteer/668/800 ... JoQAvD_BwE
The front engine cross-member adds a lot of rigidity to the front suspension. Tight and responsive.
Joe
Do the discs, one of the best changes Ive made on mine,,, and I've made a few!
Just a few?SASSY wrote: ↑Tue May 18, 2021 3:33 pmDo the discs, one of the best changes Ive made on mine,,, and I've made a few!
Fred
I'm new here but I gotta agree Disks were the best conversion Ive madeSASSY wrote: ↑Tue May 18, 2021 3:33 pmDo the discs, one of the best changes Ive made on mine,,, and I've made a few!
Fred