ITS TIME TO SWAP

390 & up cid Monster Motors
User avatar
fryedaddy
Posts: 598
Joined: Sun Nov 02, 2014 11:40 pm
Location: east tn

Re: ITS TIME TO SWAP

Post by fryedaddy »

im just putting a few miles on my new clutch,trying to break it in.im starting to trust it more.every time i do a engine swap or major rebuild of something i like to take alot of short trips around the block,or to the store checking for problems.i drove it yesterday to the store and some guy came over to check my car out.he was looking at my engine[no hood]and he said you are dripping water.all it needed was a screwdriver to tighten the top rad hose.little things like that will bight you if you just take off on a long ride after a rebuild.
Image

fryedaddy

Joe Travers
Posts: 681
Joined: Mon Sep 21, 2020 5:23 pm
Location: Louisiana

Re: ITS TIME TO SWAP

Post by Joe Travers »

I've been shaking my car down for 8 months, brother :wink:
Chip away at a LOT of little things to make it the best it can be. Longest drive last week, 80 mile round trip.
Need rear tire/wheel balance check this week to address vibration at highway speed.

Joe
Image

1963 1/2 Custom Hardtop

Post Reply